Jump to content
Sign in to follow this  

Roland Jupiter 4

   0 reviews  -  1303 views

    Description
    The Jupiter-4's basic architecture consisted of four identical voice cards, each with a VCO (and sub-oscillator), resonant low pass VCF (Roland BA662 in earlier revisions or IR3109 in later models IC, which could self-oscillate), and variable-gain amplifier (VCA). Modulation included an Attack-Decay-Sustain-Release (ADSR) envelope for the filter, and another for the voltage-control amplifier and a final level output with an overload LED, as well as a separate unmemorized master volume control. The filter ADSR could be inverted, allowing for "upside down" modulation. The final VCA level setting could be memorized in user presets, and was prior to the overall master stereo output volume. The LFO, routable to oscillator pitch, pulse width, filter cutoff and amplifier, was notable for being able to reach audio frequencies, allowing for crude FM and AM synthesis. Those settings were memorized in the user presets but a fully adjustable depth remained independently configurable through the pitch wheel to combinations of VCO, VCF and VCA, as well as a bend range. The VCOs can garner unstable tuning if aging or low-quality electrolytic capacitors are used (two for each voice card). Synthesizer repair shops can replace these tuning capacitors with stable polystyrene capacitors for an instant perfect tune. Individual oscillator card VCO tuning is accessed by four capped holes in the middle of the back of the case, but the unit should be allowed to warm up before adjusting for at least 20 to 40 minutes prior to adjustment.

    The Jupiter 4's two most distinctive features were provided by virtue of its "compuphonic" digital control of the four voice cards, made possible by two Intel 8048 chips:[1]

    An arpeggiator, with a choice of up, down, up/down, or random mode. The arpeggiator can be prominently heard in Duran Duran's 1982 hit single "Rio." Switches on the far left select between the internal rate, adjustable, or an external source, such as the clock out of its contemporary, the Roland CR-78—Roland's first programmable analog drum machine. A hold button on the lower front panel allows users to latch or set a constantly running arpeggiator pattern, useful when playing leads on another machine over a JP-4 pattern. Otherwise the arpeggiation only responds when keys, individual or chords, are pressed. This allows for a more fluid and less rigid timing in live situations when playing with others.
    Left-hand modulation from the keyboard is unusual. The polyphonic portamento or glide feature can be used very effectively with in conjunction with the arpeggiator and any preset. An octave down switch by the modulation wheel is also available independent of memorized settings. Unlike Moog or Sequential, the Roland modulation wheel goes left to right, and is spring-loaded. A short spike on top of the spring-loaded modulation wheel allows for an unusual rapid fanning, but risks damage to this out of production part. Knobs allow depth of pitch bend or LFO modulation, in addition to the amounts assigned and memorized. Toggle switches select bend or LFO to the wheel and onto any combination of VCO/VCF/VCA in an unusual selection pattern, all controlled by a single wheel motion.
    Four voice assignment modes, which, as well as simple one-VCO-per-voice polyphony, included the ability to affect four-VCO unison when one key was pressed, two VCOs per voice when two keys were pressed, and one VCO per voice when three or four keys were pressed. This effect can be heard on tracks such as "Seconds" by The Human League and "I Dream of Wires" by Gary Numan.
    The final signal path also included a simple high-pass filter and a lush stereo chorus effect based on two, now rare, MN3004 ICs. The chorus circuit board is located underneath the modulation wheel, and has one control: a front button for enabling/disabling the effect. It is lush and wide, supplying a pseudo stereo effect when both outputs are used. This filter, as well as other parts of the machine, also use the BA662 VCA chips, which are also rare. Despite evidence against its alleged sonic magic, the BA662 remains sought by many x0xb0x builders,[citation needed] a superior clone DIY kit of the Roland TB-303. Numerous such chips are used in the early JP-4 circuits and the Roland TB-303.

    The Jupiter 4 had ten preset sounds and also featured eight memory locations for user-created patches. Saving to those locations requires two widely separated write record buttons to be held, to protect against accidental writing. A battery located deep between the chorus and power supply preserves the contents of the memory ICs.

    A quirk that catches many first-time users is that the lower right preset and user memory buttons disengage most programmable controls to the right of the arpeggiator section when a user or factory preset is used.[citation needed] The controls to the right of the arpeggiator are only live when the yellow manual button is selected. The controls are analog switches and potentiometers, but do not adjust the synth cards directly. They are supplied with hi/low logic voltages or 0–5 volt voltages. Multiplexers and analog to digital converters read the settings, then send them in digital form to the CPU. The CPU then converts these parameters to analog control voltages, and sends them to the analog voice cards and envelope gates. It is a remarkably stable hybrid pioneer with a great analog sound.

    Despite not being incredibly popular,[citation needed] it did find its way into the hands of some musicians, most of which were associated with the new wave and synthpop music scenes (see below). Phil Oakey of The Human League eulogized that despite its limitations "the Jupiter 4 will be tattooed on my heart for ever"
    Images
    Architecture
    Type: Analog
    Synthesis: Subtractive
    Oscillators
    Oscillators: 1
    Waveforms: Pulse, Pulse Variable, Saw Down, Saw Up, Sine, Square, Triangle
    Osc Modulation: Fader, Knob, LFO
    Envelopes
    Envelopes: 2
    Evelope Paramerters: Attack, Decay, Sustain, Release
    Filters
    Filters: 2
    Types: High Pass, Low Pass, Resonance
    LFO
    LFO: 1
    LFO Parameters: Saw Up, Saw Down, Sine, Square
    Polyphony & Tuning
    Polyphony: 4
    Timbrality: 1
    Tuning: Standard
    Modes: Mono, Polyphonic
    Patches
    Patches RAM: 1
    Arpeggiator
    An arpeggiator, with a choice of up, down, up/down, or random mode
    Effects
    Ensemble/Chorus
    Case
    Case: Keyboard
    Keyboard: 49 keys, Wood
    Controls: Faders, Joy Stick, Knobs
    Weight: 19kg
    Connections
    Audio Output Connections: 1/4" Phone Jack
    Audio Output Count: 3
    Power: 30w
    Production
    Year Released: 1978
    Year Discontinued: 1981
    Manuals & Documents

    Product Links
    Company Product Sites:
    [+] www.retrosound.de
    Pricing
    Used Price: $1700-$3,500 - convert
    Shopping
    YouTube Videos
Sign in to follow this  


User Feedback

Create an account or sign in to leave a review

You need to be a member in order to leave a review

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

There are no reviews to display.




×